Www

iewood.com

MAKE MONEY with the

L0G0S0L 4-Head Planer/Moulder

LOGOSOL, Inc. • 116 Solleftea Drive • US-Madison • MS 39110- USA Toll FREE: 1-877-LOGOSOL • Fax +1-601 856 9535 • ¡nfo0logosol.com-nranv.logosol.com

Enjoy the Benefits of HVLP with a FUJI!

Visit www.fujispray.com or call 1-800-650-0930

Circle No. 135

► Non-Bleed Sprayguns

► High-Efficiency Aircap

► Exciting New Models

► Standard or Quiet Turbines

► Industrial-rated

LOGOSOL Brings you a LOGOSOL

www.logosol.com

News - Success Stories - Web Store Owners Forum and On-Une Videos

Order Line: 800.849.8876 4618 GA Highway 123 N For a Catalog: 800.746.3233 Toccoa GA 30577 j [email protected]

To cut thin strips, set the saw fence for the desired strip thickness. Set the blade a little higher than the stock to be cut. Note: Use a zero clearance throat plate to prevent offcuts from jamming between the blade and the throat plate.

Cut Grooves

To cut a groove on the edge of a long, wide board, lock the tall fence to the rip fence. Then, adjust the blade height and fence position and start grooving. Use featherboards for additional stability.

T"h!n Rips

Resaw Narrow Stock

To cut a groove on the edge of a long, wide board, lock the tall fence to the rip fence. Then, adjust the blade height and fence position and start grooving. Use featherboards for additional stability.

The tall fence can also be used as a base for vertical featherboards. Use this setup to guarantee a uniform depth on dadoes and rabbets. Simply clamp the tall fence to the saw's fence and add two featherboards using the same bolts and knobs as for the hold-downs.

Attach the hold-down to the tall fence and lower it onto your stock.Tighten the knobs and you're ready to rip. Note:The stock needs to be wider than the hold down so it can be held against the fence as the cut is made.

Cut Grooves

To cut thin strips, set the saw fence for the desired strip thickness. Set the blade a little higher than the stock to be cut. Note: Use a zero clearance throat plate to prevent offcuts from jamming between the blade and the throat plate.

The setup for resawing is identical to ripping thin strips. If the stock is taller than your saw blade, make one cut, then flip the board end for end and cut again. Place a featherboard in front of the blade, to hold the stock against the multipurpose fence, and a zero-clearance throat plate.

Cut Dadoes/Rabbets

Our 718 paid for itself in 3 months. We've run over a million lineal feet through if and we've

— James Tolley, President, J&D Woodworks Inc., Black Hawk, SD

Choose from over 500 patterns!

Woodmastef

Woodworking Tools and Installation Tips

Woodworking Tools and Installation Tips

There are a lot of things that either needs to be repaired, or put together when youre a homeowner. If youre a new homeowner, and have just gotten out of apartment style living, you might want to take this list with you to the hardware store. From remolding jobs to putting together furniture you can use these 5 power tools to get your stuff together. Dont forget too that youll need a few extra tools for other jobs around the house.

Get My Free Ebook


Post a comment