Wooden Runner L

Size to fit miter groove in tablesaw.

compound on the bolts, then screw in the bolts just enough so the cover slides freely up and down without binding.

For maximum efficiency and holding power, I suggest using at least a 7-amp shop vacuum. To slice consecutive sheets of veneer, adjust the distance between the fence and the blade to the desired veneer thickness. Limit the amount of wood that overhangs the jig to 1 in. or less, and make sure the stock butts firmly against the indexing fence. When working with stock over 1 in. wide, adjust the fence to the width of the stock minus the desired vcnccr thickness. Make sure to use a zcro-clcar-ancc insert to prevent thin slices of vcnccr from jamming the blade. A

DAYA PIYASENA is a software designer and amateur woodworker.

He lives in Georgia.

BEST SOLUTION WINS!

Have a shop jig or fixture you'd like to share? Send a photo or sketch with an explanation to "Shop Solutions," American Woodworker, 33 E. Minor Street, Emmaus, PA 18098. Next issue's contributor will receive this Porter-Cable CF1400 Jetstream compressor, valued at $348.

10-ยป AMERICAN WOODWORKER A APRIL 1998

da copyright

POWERMATfC im

0 0

Post a comment