Tighten screws to grip knife.

that I can clamp to my tablcsaw table. The wooden holder for the knife has a kerf chat's cut at 45°. Round-head screws and threaded inserts are located on the holder every 3 in. to secure the knife during grinding. The holder runs against an adjustable fence that I clamp to the base of the jig. It usually takes just two or three passes to regrind a knife.

John Renneker Tallahassee, FL

Miter-Gauge Upgrade

If you get as annoyed as I do with the sloppy fit of miter-gauge bars, here's what to do about it. Chuck a #17 twist bit in the drill press and drill a hole near

Was this article helpful?

0 0

Post a comment