Spraying Vertical Surfaces

Adjust the air cap for a horizontal fan pattern. Adjust the fluid volume and the air volume to make a 6-in. fan pattern.

1. Aim the gun at a point above the cabinet and pull the trigger. Move down the cabinet and release the trigger when you're past the bottom edge.

2.The next pass starts below the bottom, overlapping the first pass by 50 percent. Repeat the up and down pattern until the side is covered.

START AT , BACK

Was this article helpful?

0 0
A Course In Wood Turning

A Course In Wood Turning

Ever wondered what wood turning is all about? Here are some invaluable information on how to make beautiful items out of wood! That one little strategy from A Course In Wood Turning that I implemented not only worked, but the results were completely astonishing. I had never seen anything like it! Now, keep in mind that I had tried a lot of other products up until this point. You name it, I probably tried it! That’s how desperate I was to improve my skills with wood turning.

Get My Free Ebook


Post a comment