Bearing

'LATE

7 Saw the handles from the blank, using a sacrificial sled— nothing more than a scrap of plywood. Fasten the blank to the sled with double-faced tape, so the small handles stay attached and stable after the cut.

1 "1 Angled blocks and a flat surface put clamp pressure on the joints. First I I clamp the ends to a piece of MDF (1).Then clamp the sides to the ends, using angled blocks (2). Finally, clamp the ends to the sides (3).

Pattern 1 Handle

I" Grid

Pattern 1 Handle

I" Grid

I,

Was this article helpful?

0 0

Post a comment