Assemble Ends

Finally, each of the end assemblies can be end rail must be temporarily placed between glued and clamped together, see Fig. 12. Af-the front and back leg. To support the arm ter the slats have been glued in the mortises, while marking the bevel, I used a scrap piece countersink a deck screw through the back as a temporary spacer block, sedFig. 10. leg into the end of the arm, see Fig. 12a.

Now cutthe bevel across the back of each Now, set aside the end assemblies until arm, see Fig. 10a.

the back and front assemblies are complete.

W Radius

Waste

Was this article helpful?

0 0

Post a comment