Very similar to the K2, but in place of a toggle clamp, material is held in place by a foot-actuated pneumatic clamp. The drill bit is guided through the bushing on a pair of spring-loaded rails. Adjustable flip-stops control pocket location.


Hardened-steel drill guides carry lifetime warranty

Controlling the drill bit with the spring-loaded guide prevents the tip from contacting the top of the jig, keeping the bit sharp longer Pneumatic clamp significantly speeds up the process

PHIJQ ■ Requires an air compressor vUllO B Best suited for 3/4-in. thick material

COST: S329, plus s&h. from Kreg Tool: (800) 447-8638.

Was this article helpful?

0 0

Post a comment