And Fill Strips To Fit Photo Assembly

FILL STRIP 1/4"W* X 5/16"H x 2-1/4"L

FILL STRIP 1/4"W* x 5/16"H x 1-1/4"L

5 Rout a centered slot in each piece.

Center the bit by eye.Then make two passes, one on each face. Rout halfway, as before, then flip the work-piece. Once the slot is established, you can rout against the grain to widen it.

Reduce the slots' depth to 3/16-in. by gluing In fill strips. Leave the inside corner 1/2-in. deep, to accommodate the square corners of the glass.

7Drill holes for the rare earth magnets using a fence and a stop block. The fence centers the hole between the faces; the stop block centers it between the edges.

Grooved Frame

Was this article helpful?

0 0

Post a comment