Handle

Tapering Sled

FRONT SUPPORT 3/4" x 3/4" x 4-3/4" (TYP.)

Cut the paddle's three main pieces from a single board. First, rip the handle.Then band saw the remaining section into the two side pieces, after marking radii on opposite sides of the centerline.

Add accent strips between the handle and the sides and glue the paddle together.The wide part that holds the pizza is called the "blade."

Cut the paddle's three main pieces from a single board. First, rip the handle.Then band saw the remaining section into the two side pieces, after marking radii on opposite sides of the centerline.

Install the paddle in the tapering sled. Secure it by driving a screw Taper the paddle using the planer.Take light passes until the

through a hanging hole drilled in the end of the handle.

blade's leading edge is 1/8" thick.

through a hanging hole drilled in the end of the handle.

blade's leading edge is 1/8" thick.

Ease the handle's sharp edges to create a comfortable grip.

Round the front comers of the blade and bevel its edge to slightly less than 1/16". ft*

Since 1972

k OHIO'S ^ LARGEST P TOOLSTORE!

Tool

5 Piece 1/2 Shank

Undersized Plvwootl Bit Set CCQ Off

f Ofler Expires

Includes:

FREE!

Was this article helpful?

0 0
Woodworking Tools and Installation Tips

Woodworking Tools and Installation Tips

There are a lot of things that either needs to be repaired, or put together when youre a homeowner. If youre a new homeowner, and have just gotten out of apartment style living, you might want to take this list with you to the hardware store. From remolding jobs to putting together furniture you can use these 5 power tools to get your stuff together. Dont forget too that youll need a few extra tools for other jobs around the house.

Get My Free Ebook


Post a comment