Clocks

Thompson Table Clock

Make from W thick material.

The Thompson table clock is designed to hold a 2" diameter clock insert. (Modify the size of the mounting hole as needed to fit your insert.)

Scroll Saw JigScroll Saw Clock

LEGS

Make 4

Note: Locations arc shown where parts attach to the base. Do not cut out these areas.

Little Dutch Windmill Clock

Make the building from W thick material.

It is designed to hold a 1 7/u" diameter clock insert that requires a 1 VnM diameter mounting hole.

Scroll Saw Mini Clock MilitaryScrollsaw CutoutsScroll Saw Pattern Kitchen

TULIPS

Make 2

Scroll Saw Pattern KitchenScroll Saw Pattern Kitchen

The edge can be bevel-sawn at 10 to 15 degrees as desired.

Miniature Kitchen Clock

Scroll Saw Clocks

Grille

Scroll Saw Clocks

Upper overlay

Front panel

Upper overlay

Grille

Front panel

FRONT VIEW

Upper overlay

Case overlay

Grille

Front panel

Grille

Front panel

Upper overlay

Case overlay

Scroll Saw Pattern Kitchen

Va x Va ' Upper stop

Back panel

Va x Va " Cleat

Base

Foot

Va x Va ' Upper stop

Back panel

Va x Va " Cleat

Base

Foot

SIDE VIEW

OVERLAY

Scroll Saw Pattern Kitchen

Make from W thick material.

The grille of this kitchen clock is designed to hold a 17/I6M diameter clock insert that requires a 1V«W diameter mounting hole.

Scroll Saw PatternsClock Overlayed With Degrees

CASE OVERLAY

Make from W thick material. Miter the joints as shown.

45 degree miters

Scroll Saw Trim

CLOCK CASE

Make from six pieces of l/V thick material

Make from W thick stock.

Bevel ends at 22]/2 degrees.

Clock Overlayed With DegreesScroll Saw Clock Pattern

SIDES

Make two from '/V1 thick material.

Bevel top end at 22 V2 degrees.

Make the back panel so that it can be removed for access to the movement. A knob can be fastened to the back if desired.

This clock is designed to utilize a miniature pendulum drive unit, similar to the illustration at right. Follow manufacturers instructions to install. Attach to the back panel, centered on the location indicated on the pattern.Trim the pendulum rod to the desired length.

Scroll Saw Clock PatternExploded View Clock Movement

BACK PANEL

Center the pendulum drive unit and attach here.

Make from i/V* thick stock.

Refer to the side view on page 58, which shows the installation of upper and lower stops inside the clock case. Make and install these stops to prevent the door from being pushed too far inside the clock case.

BOTTOM

Make from W thick stock.

! 1 1

p

| FEET

• Make two from W thick

' material-

| Bevel front edge and two side

edges at 45 degrees. See edge

I views and exploded view at

i 1

1 ; i

1 \

BASE

Make two from W thick material.

Bevel the front edge and two side

edges at 45°.

/ \

Beagle Pup 150 Plan

EXPLODED VIEW

Woodworking Projects For Scrool Saw

EXPLODED VIEW

The Complete Guide To Wood Finishing

The Complete Guide To Wood Finishing

Wood finishing can be tricky and after spending hours on building your project you want to be sure that you get the best outcome possible. In The Complete Guide To Wood Finishing you will learn how to get beautiful, professional results no matter what your project is, even if you have never tried your hand at wood finishing before. You will learn about every step in the wood finishing process from a professional wood finisher with years of experience.

Get My Free Ebook


Responses

  • Lea Richter
    How to make a scrollsaw clock pendulum?
    2 years ago
  • elio
    How to make scroll saw clock pattern?
    1 year ago

Post a comment