Construction Procedures

Lay out the tools to establish the configuration of the box. Then make a full-size drawing (see pp. 72-75), make up a cut list and gather the materials you will need.

Constructing the lower box-

Cut the plywood parts to size and lay out and drill the holes for the swing arms and the swing-arm pivot bolts, as shown in the drawing on p. 142. Also drill for the pivot bolt and the stop dowel for the! swing-down handle. Dado the sides and ends for the bottom panel, then glue and screw these components to the four pine corner blocks. Apply glue to the dadoes, j then slide the bottom panel in place before screwing in the last end piece. Make sure that the box is square by checking its diagonal measurements, then set it aside to dry.

Was this article helpful?

0 0
A Course In Wood Turning

A Course In Wood Turning

Ever wondered what wood turning is all about? Here are some invaluable information on how to make beautiful items out of wood! That one little strategy from A Course In Wood Turning that I implemented not only worked, but the results were completely astonishing. I had never seen anything like it! Now, keep in mind that I had tried a lot of other products up until this point. You name it, I probably tried it! That’s how desperate I was to improve my skills with wood turning.

Get My Free Ebook


Post a comment