M

cabinets and the panels separately, then secure the panels into rabbets in the rear of the cases with screws.

Andy Rac Assistant editor

T-Slot Miter Gauge

©I'm interested in building the bottomless cut-off box shown in AW #40. Where can I get steel bar stock to match the T-type miter grooves on my Delta tablesaw?

George Gumbert Apollo, PA

OWith a couple of fender washers, two machine screws, and some steel bar stock, you can make a bar that works just like the one on Delta's miter gauge. The drawing shows how a fender washer can be screwed in a slot milled in the bar stock so that the washer rides in the T-groove.

For bar stock, use cold-rolled steel, available from your local metal supplier,

Countersink for screw.

Was this article helpful?

0 0

Post a comment